Assembly & Operation - Worx WG184 Manual Del Usario

ASSEMBLY & OPERATION
Action
Assembly
Assembling the Main Handle
Assembling the Safety Guard
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run
when 2 batteries are installed.
It is recommended to use
the same two batteries and
charge the two batteries at
the same time.
• Using two different sized
batteries or if one battery
isn't fully charged then the
machine will only run to the
lowest common denominator.
Checking the battery charge
condition
NOTE: Fig. C3 only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE:
• The batteries are shipped
12
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
Operation
On/Off Switch
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay
down the tool.
Trimming
-Adjusting the Trimmer Head
-Adjusting the Auxiliary handle
Edging
-Edger wheel storage
Command feeding the line
2-in-1 Cordless Grass
Trimmer/Edger
Manually feeding the line
Replacing the trimmer line and
Figure
spool
Manually winding the line
See Fig. A
See Fig. B
BATTERY STATUS (See Fig. C5)
Before starting or after use, press the button beside
the power indicator light on the machine to check
the battery capacity. The indicator lights displays the
battery condition as follows:
See Fig. C1, C2
indicator status
Five green lights
(
illuminated.
Two, three or four
green lights are
illuminated.
See Fig. C3
Only one green
light (
) is illuminated.
No light is
illuminated.
See Fig. C4
Only one light is
flashing twice per
cycle.
Only one light
See Fig. C5
is flashing three
times per cycle.
Only one light is
flashing four times
per cycle.
See Fig. D
See Fig. E
See Fig. F1, F2
See Fig. G
See Fig. H1-H4
See Fig. I
See Fig. J
Battery power
The two batteries are in a
) are highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the more
battery capacity.
At least one battery is
depleted and needs to be
charged.
At least one battery is not fully
installed or battery may be
defective.
At least one battery is over
discharged (please refer to
the battery charge condition),
please recharge the two
batteries at once before use
again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Raise the cutting height or
push slowly.
See Fig. K
See Fig. L,
M, N
See Fig. O, P ,
Q, R
Battery condition
EN