Assembly & Operation - Worx WG183E Manual Original

its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such
as the times when the tool is switched off and when it
is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
ASSEMBLY & OPERATION
ACTION
Assembly
Assembling the Trimmer Shaft
Assembling the Auxiliary Handle
Assembling the Safety Guard
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
• When you use two batteries
with different power, the
machine will only run to the
lower common denominator.
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
OPERATION
On/Off Switch
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
Cordless Grass Trimmer
Trimming
-Adjusting the Auxiliary handle
Manually feeding the line
Removing the Cap
Cutting Head
Changing the line spool
Manually winding the line
BATTERY STATUS (See Fig. D4)
Before starting or after use, press the button beside
the power indicator light on the machine to check the
battery capacity. During operation, the battery capacity
will be indicated automatically by the battery power
indicator.
The indicator constantly senses and displays the battery
FIGURE
condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
See Fig. A
See Fig. B
See Fig. C
Five green lights
(
illuminated.
Two, three or four
green lights are
See Fig. D1,D2
illuminated.
Only one green
light (
is illuminated.
No light is
illuminated.
See Fig. D3
Only one light is
flashing twice per
cycle.
Only one light is
See Fig. D4
flashing three
times per cycle.
Only one light is
flashing four times
per cycle.
See Fig. E
Battery power
indicator status
The two batteries are in a highly
) are
charged condition.
The two batteries have a
remaining charge. The more lights
are illuminated, the more battery
capacity.
At least one battery is almost
) depleted and needs to be
charged.
At least one battery is not fully
installed or battery may be
defective.
At least one battery is over
discharged (please refer to
the battery charge condition),
please recharge the two
batteries at once before use
again or storage.
At least one battery is hot, wait
for them cool down before start
again.
The machine is over load. Raise
the cutting height or push
slowly.
See Fig. F
See Fig. G
See Fig. H
See Fig. I
See Fig. J
See Fig. K,L
See Fig. M, N,O,P
Battery condition
EN
13