Assembly And Operation - Worx WG163E Manual Original

ASSEMBLY AND OPERATION

NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for the cutting of grass and
weeds under bushes, as well as on slopes and edges that
can not be reached with the lawn mower.
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because of an electrical failure and hazard
will occur.
WARNING! Always wear the eye protection. Never
lean over the trimmer head. Rocks or debris can
ricochet or be thrown into eyes and face and cause
blindness or other serious injury. When operating unit,
check for the following:
Wear eye protection and heavy clothing. Hold front handle
with one hand and auxiliary handle with the other hand.
Keep unit below waist level. Work only from your right
to your left to ensure debris is thrown away from you.
Without bending over, keep line near and parallel to the
ground (perpendicular when edging) and not crowded
into material being cut.
WARNING! Make sure that line is fed out before
operation. Make sure motor is up to full speed
before trimming or edging.
WARNING! Only use 1.65mm diameter cutting
14
line. Other sizes of line will not feed properly and
will result in improper cutting head function or can cause
serious injury. Do not use other material such as wire,
string, rope, etc. Wire can break off during cutting and
become a dangerous projectile that can cause serious
injury.
ASSEMBLY & OPERATION
Action
Assembly
Assembling the Safety Guard
Mounting the Edger Wheel
WARNING: Make Sure the
ON/OFF Switch is Locked Off
to Prevent Accidental Starting.
Installing and Removing the Battery
Pack
Charging the battery pack
More details can be found in charger's
manual
2-in-1 Grass Trimmer/Edger
Checking the battery condition
(Only for WG163E.1, WG163E.2,
WG163E.3,WG163E.5)
Operation
Safety ON/OFF Switch
trimmer has been switched off; wait
until it has completely stopped then
lay down the tool.
Trimming
- Adjusting the Shaft
Prevent Accidental Starting.
- Adjusting the Trimmer Head
- Adjusting the Auxiliary handle
- Trimming
- Using the Flower Guard
Edging
- Changing the tool into the Edging
mode
- Edging
Command feeding the line
- Note: Press as needed.
Manually feeding the line
Replacing the trimmer Spool
Manually winding the line
Figure
WORKING HINTS
See Fig. A1, A2
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small length of
line is fed out.
See Fig. B
A 'clattering' noise will be heard when the lines hit the Line
Cutter. DO NOT BE ALARMED. This is quite normal. After
about 5 seconds the line will be cut to the correct length
and the noise will reduce as the motor gains full speed.
See Fig. C
If the noise of the line being cut can't be heard, more line
will need to be fed out.
To feed more line, it is first necessary to allow the trimmer
to stop completely; it must come to a complete rest, then
See Fig. D1, D2
restart, allowing the motor to reach full speed.
Repeat above until you hear the line hitting against the
Line Cutter.
WARNING! The cutting head
continues to rotate after the
WARNING! Make Sure the ON/
OFF Switch is Locked Off to
See Fig. D3
See Fig. E
See Fig. F
See Fig. G1, G2
See Fig. H
See Fig. I1
See Fig. I2
See Fig. J1, J2
See Fig. K
See Fig. L
See Fig. M
See Fig. N1, N2, N3
See Fig. O1, O2,
O3, O4
EN