Sequencing; Sequence Sewing; Selecting Stitch Patterns; Selecting Letter Stitches - Singer C440 Manual De Instrucciones

Sequencing

SEQUENCE SEWING

You can combine stitch patterns and letter stitches into a
sequence. There are 2 memories for storing stitch sequences.
Each stitch sequence can contain up to 40 characters.
To enter the sequence mode, press the Sequence button at
the home screen.
LCD will show the Sequence Screen.
Selecting Stitch Patterns
1. Select the desired stitch patterns in the same manner as
that used for normal sewing. (See page 14 for information
on selecting stitch patterns)
The selected patterns will display at the top left side of the
LCD screen.
2. After selecting a pattern, use the same procedure to select
the next stitch pattern. The selected pattern will be added,
and it will display on the left side of the LCD screen below
the previously selected pattern.
NOTE: Some patterns may not be combined
into the sequence. If you select a pattern that
cannot be combined, a message will appear on
screen to alert you of this. Press the " ✓ " button.
Selecting Letter Stitches
1. To enter a letter stitch into the sequence, press the letter
button on the LCD screen, which is indicated by a lower
case 'a', as shown below.
The letter style selecting screen will appear.
2. Press the left button for the Block font, press the right
button for the Cyrillic font. Selected button will be
highlighted.
3. Press the "✓" button.
Uppercase letter of selected style will appear.
4. Press the desired letter directly. Press the character tabs
(located at the bottom of the LCD screen) to change lower
case, numbers, etc.
a. Uppercase letters
b. Lowercase letters
c. Numeric letters and special letters
5. Selected letters will appear on the top line of the LCD
screen.
6. The Arrow buttons on top line will move the cursor.
7. To insert the letter, move the cursor to the inserting point
and select letter.
To delete the letter, move the cursor to the right side of the
letter to be deleted, then press the Delete button (d).
To change the letter style, press the Style button (e).
8. When sequencing of letters is completed, press the "✓"
button.
The Sequence Screen will appear again.
a b c
e
39
d