Timer - Bosch BFL634G.1 Instrucciones De Uso

Timer

en
Press the start/stop button
4.
The cooking time counts down on the display.
Notes
When you switch on the appliance, the highest
■
microwave output always appears in the display as a
suggestion.
If you open the appliance door during use, the fan
■
may continue to run.
Cooking time elapsed
An audible signal sounds.
The operation has finished.
To stop the signal early:
Touch the field.
s
Press the on/off button
After touching the
Note:
appears; after a short time, it automatically disappears.
Press the again for the option to increase the
s
cooking time.
Changing the cooking time
This can be done at any time.
Change the cooking time using the rotary selector.
The operation continues.
Changing the microwave output
This can be done at any time.
Touch the field for the required microwave output.
The cooking time remains unchanged.
The operation continues.
If the set cooking time exceeds the maximum
Note:
time for the microwave output of 900 W, it is reduced
automatically. The operation stops. Press the
to start the operation.
12
to start.
l
to switch off the appliance.
ÿ
button, the timer function
s
l
OTimer
Y ou can use the timer as a kitchen timer. The timer runs
T i m e r
alongside other settings. You can set it at any time,
even if the device is switched off. It has its own audible
signal so that you can tell whether it is the timer or a
cooking time which has elapsed.
Setting the timer
The maximum setting is 24 hours.
The higher the value, the longer the time intervals.
Touch the
1.
The timer is displayed.
Set the timer duration using the rotary selector.
2.
Press the
3.
Note:
few seconds.
The timer duration counts down. The display switches
back after a short time. A timer symbol is also shown on
the display.
When the timer duration comes to an end, a note
appears and an audible signal sounds. You can cancel
the audible signal early by touching the
If an operating mode with a set cooking time is
Note:
already running, the cooking time is highlighted. Touch
the field to display the timer. The timer duration is
s
highlighted for a certain amount of time and can be
altered.
Changing the timer
To change the timer, touch the
displayed in white and in focus, and can be changed by
button
using the rotary selector.
Cancelling the timer
If you want to cancel the timer, reset the duration on the
timer to zero. Once the change has been applied, the
symbol is no longer lit up.
field.
s
s field to start.
The timer will also start automatically after a
s
field.
s
field. The timer is