Connecting Output Terminals - PIONEER DJ DJM-750MK2 Manual De Instrucciones

Connecting output terminals

1 When connecting a mobile device, use the cable supplied with the device.
For information on compatible mobile devices, see the Pioneer DJ site below.
pioneerdj.com/support/
2 Also connect the external effector to the [RETURN] terminal (input terminal).
3 Be sure to use the [MASTER1] terminals for a balanced output. If it is connected to an unbalanced input (such as RCA) with an XLR to RCA con-
verter cable (or converter adapter), etc., the sound quality may be lowered or noise may occur.
Use the [MASTER2] terminals for an unbalanced input (such as RCA).
4 Be careful not to accidentally insert the power cord of another unit to [MASTER1] terminal.
Do not connect the terminal that can supply phantom power to the [MASTER1] terminal.
5 Be sure to use the [BOOTH] terminals for a balanced output. If they are connected to an unbalanced input (such as an RCA or TS input) with an
TRS to RCA converter cable (or converter adapter), TS cable, etc., the sound quality may be lowered or noise may occur.
6 Connect headphones to either the phone jack or the mini jack. If both jacks are used at the same time, the sound quality and volume may be
lowered.
10
En
Mobile device
1
USB hubs cannot be used.
USB port covers
4
Power amplifier
External effector
2
L R
Power amplifier Power amplifier
3 3
(for booth monitor)
Headphones
6
Top panel of unit
Rear panel
5