Diting; Edit To Another Vcr - JVC HR-J3006UM Manual De Instrucciones

EDITING
Edit To
Another VCR
Player
AUDIO OUT
VIDEO IN
Recorder
Your VCR
VIDEO OUT
Audio/Video Cable
(not supplied)
AUDIO IN
Another VCR
You can use your VCR as the player and another VCR as the
recorder.
MAKE CONNECTIONS
1
Connect an AV cable between your VCR's VIDEO OUT
and AUDIO OUT connectors and another VCR's
VIDEO IN and AUDIO IN connectors.
When connecting to a Hi-Fi VCR, connect your
VCR's AUDIO OUT connector to the AUDIO IN L
connector on the Hi-Fi VCR.
LOAD CASSETTES
2
Insert the playback cassette into your VCR and the
cassette to be recorded on into the other VCR.
SET RECORDER'S INPUT
MODE
3
Set the other VCR's auxiliary (AV) input mode.
SELECT "EDIT" FOR PIC-
TURE CONTROL SET MODE
4
Follow the "Picture Control" section on page 19, then
select "EDIT".
NOTE:
When you select "EDIT" to dub tapes, be sure to select
"AUTO" or ("NORM" when "VIDEO CALIBRATION" is
set to "OFF") after you finish dubbing the tapes.
START PLAYER
5
Press PLAY on your VCR.
NOTE:
If you don't want to record the superimposed indication
on the edited tape, be sure to set "SUPERIMPOSE" to
OFF before pressing PLAY (
START RECORDER
6
Set the other VCR to its record mode.
29
EN
pg. 20).