Picture Control; Video Stabilizer - JVC HR-J3006UM Manual De Instrucciones

Picture Control

This feature helps you to adjust the playback picture quality
according to your preference. *The default setting is "AUTO."
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET
SCREEN
2
Move the highlight bar (arrow) to "FUNCTION SET" by
pressing CH 5 ∞ or SHUTTLE PLUS % fi, then press OK
or SHUTTLE PLUS
SELECT PICTURE CONTROL
SET MODE
3
Move the highlight bar
(arrow) to "PICTURE
CONTROL" by pressing
CH 5 ∞ or SHUTTLE
PLUS % fi, then press OK
or SHUTTLE PLUS
select the desired mode.
AUTO*: Normally select
"AUTO".
It automatically adjusts the picture quality.
* When "VIDEO CALIBRATION" is set to "OFF"
( pg. 22) , you can only select "NORM"
instead of "AUTO".
EDIT: Select when you dub tapes.
SOFT: Select when you want to soften the picture.
SHARP: Select when you want to sharpen the picture.
NOTES:
When you select "EDIT", "SHARP" or "SOFT", the
selected mode will not change until you select again.
When you select "EDIT" to dub tapes, be sure to
select "AUTO" (or "NORM" when "VIDEO CALIBRA-
TION" is set to "OFF") after you finish dubbing the
tapes.
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTE:
Select "EDIT" when you are dubbing tapes. Refer to page 29.
.
FUNCTION
VIDEO CALIBRATION
=PICTURE CONTROL
AUTO TIMER
SUPERIMPOSE
AUTO SP = EP TIMER

VIDEO STABILIZER

SELECT WITH (5,∞) AND (OK)
to
PRESS (MENU) TO END
Video Stabilizer
By activating the Video Stabilizer you can correct vertical
vibrations in the picture when playing back unstable recordings
that were made on another VCR. When this function is set to
"ON", vertical vibration will be automatically corrected. *The
default setting is "OFF".
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET
SCREEN
2
Move the highlight bar
(arrow) to "FUNCTION
SET" by pressing CH5 ∞ or
PUSH JOG% fi , then press
OK or PUSH JOG
ON
AUTO
OFF
ON
OFF
ACTIVATE VIDEO STABILIZER
ON
3
Move the highlight bar
(arrow) to "VIDEO
STABILIZER" by pressing
CH5 ∞ or PUSH JOG% fi,
then press OK or PUSH
JOG
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
When you finish viewing the tape, be sure to set it back to
"OFF".
Regardless of the setting, this function has no effect during
recording and during special-effects playback.
The Superimpose mode indications may jitter vertically when
"VIDEO STABILIZER" is set to "ON".
To watch recordings with close-caption, it is necessary to set
the Video Stabilizer function to "OFF".
= FUNCTION SET
TUNER SET
INITIAL SET
.
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
=VIDEO CALIBRATION
PICTURE CONTROL
AUTO TIMER
SUPERIMPOSE
to set to "ON" .
AUTO SP = EP TIMER
=VIDEO STABILIZER
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
19
EN
MAIN MENU
FUNCTION
ON
AUTO
OFF
ON
OFF
ON