Functional Description - Milwaukee 6088-30 Manual Del Operador

1. Rear handle
2. Trigger
3. Lock-on button (select models)
4. Handle release button (select models)
5. Side handle
6. Wheel guard (select models)
7. Grinding wheel (select models)
8. Guard adjustment lock lever
(select models)
9. Spindle lock button
10. Side handle socket
8
Specifi cations
Cat. Volts
No. AC/DC Amps
6088-30 120 15
6088-31 120 15
6089-30 120 15
120
6089-31 15
Symbology
Double Insulated
Volts Alternating Current/Direct Current
Amperes
No Load Revolutions per Minute (RPM)
Underwriters Laboratories, Inc.,
United States and Canada
Mexican Safety Standards
page 4

FUNCTIONAL DESCRIPTION

7
Spindle
No Load Thread Wheel
RPM Size Size
6000 5/8"-11 7"/9"
6000 5/8"-11 7"/9"
6000 5/8"-11 7"/9"
6000 5/8"-11
7"/9"
1
4
5
10
6
GROUNDING
Improperly connecting the grounding wire can result in the risk of
electric shock. Check with a qualifi ed electrician if you are in doubt
as to whether the outlet is properly grounded. Do not modify the
plug provided with the tool. Never remove the grounding prong
from the plug. Do not use the tool if the cord or plug is damaged. If
damaged, have it repaired by a MILWAUKEE service facility before
use. If the plug will not fi t the outlet, have a proper outlet installed
by a qualifi ed electrician.
Grounded Tools: Tools with Three Prong Plugs
Tools marked "Grounding Required" have a three wire cord and three prong
grounding plug. The plug must be connected to a properly grounded outlet
(See Figure A). If the tool should electrically malfunction or break down,
grounding provides a low resistance path to carry electricity away from the
user, reducing the risk of electric shock.
The grounding prong in the plug is connected through the green wire inside
the cord to the grounding system in the tool. The green wire in the cord must
be the only wire connected to the tool's grounding system and must never be
attached to an electrically "live" terminal.
Your tool must be plugged into an appropri-
ate outlet, properly installed and grounded in
accordance with all codes and ordinances.
The plug and outlet should look like those in
Figure A.
Double Insulated Tools: Tools with Two Prong Plugs
Tools marked "Double Insulated" do not re-
quire grounding. They have a special double
insulation system which satisfi es OSHA re-
quirements and complies with the applicable
standards of Underwriters Laboratories, Inc.,
the Canadian Standard Association and the
National Electrical Code. Double Insulated
tools may be used in either of the 120 volt
outlets shown in Figures B and C.
2
3
(on bottom)
WARNING
Fig. A
Fig. B Fig. C
9