V2 CITY4-EVO Manual De Instrucciones página 48

PARAMETER VALUE
En.SA
no
Si
t.AP
0.0"-5'00
t.Ch
0.0"-5'00
t.APP
0.0" - 2'00
t.ChP
0.0" - 2'00
t.SEr
0.5"- 1'00
no
SEr.S
Si
no
t.ASE
0.0"- 1'00
DESCRIPTION
ENERGY SAVING function
When the function is active and the LOW ENERGY module is installed,
the control unit deactivates the display, the photocells, and all the
devices powered by a terminal box under determined conditions.
NOTE: If the LOW ENERGY module is not installed, the control unit
deactivates only the display.
The control unit activates the ENERGY SAVING mode under the
following conditions:
• 30 seconds after completion of an operational cycle
• 30 seconds after an opening (if automatic closure is not enabled)
• 30 seconds after exiting the programming menu
The control unit exits from the ENERGY SAVING mode in these cases:
• If an operational cycle is activated
• If one of the keys on the control unit are pressed
Function deactivated
Function activated
Opening time
Adjustable time from 0 seconds to 5 minutes
Closing time
Adjustable time from 0 seconds to 5 minutes.
NOTE: To avoid that the door does not close completely, we
recommend to setup a longer time than
Partial opening time (pedestrian access)
When the control unit receives a Start Pedestrian command, it will open
leaf for a shorter time.
Max allowed time to be setup is
Partial closing time (pedestrian access)
When the control unit receives a Start Pedestrian command, it will use
this time to close the gate. Max allowed time to be setup is
NOTE: To avoid that the door does not close completely, we
recommend to setup a longer time than
Lock time
Before the opening phase begins, the control unit will energize the
electric lock in order to release it and enable the gate motion.
t.SEr
time will fix the energizing time.
m
WARNING: in case the gate has no electric lock, set the
no
value
Function deactivated
Silent Locking Mode
Function activated (140 Hz)
Function deactivated (50 Hz)
Lock advance time
While the electric lock is energized, the gate will stay standstill for
t.ASE
time, to make its release easier.
t.ASE t.SEr
In case is lower than
while the doors will start moving.
m
WARNING: in case the gate has no electric lock, set the value
0.0"
t.AP
opening time.
t.AP
t.Ch
t.APP
opening time
, the lock energizing will go on
- 46 -
AntE SCor
no no
20.0" 20.0"
21.0" 21.0"
6.0" 6.0"
7.0" 7.0"
.
2.0" no
Si Si
1.0" 0.0"
MEMO