V2 CITY4-EVO Manual De Instrucciones página 49

PARAMETER VALUE
t.inv
no
0.5" - 1'00
t.PrE
0.5" - 1'00
no
t.PCh
no
0.5" - 1'00
Pot
30 - 100
SPUn
Si
no
rAM
0 - 6
rA.AP
no
1 - 50
rA.Ch
no
1 - 50
DESCRIPTION
Backlash time
Function deactivated
To facilitate uncoupling of the electrical lock, it may be useful to
control the motors before starting opening for a short time.
The control unit controls the motors in reduced power in closing
direction for the setup time
Pre-blinking time
Before any gate movement, blinker will be activated for
to warn about the incoming motion
Function deactivated
Different closing pre-flashing time
The closing pre-flashing time corresponds to
If this parameter has a value assigned to it, the control unit will
activate pre-flashing prior to closure for the length of time set in this
menu
Motor power
The displayed value is the percentage of max. motor power.
WARNING: In case an hydraulic motor is used, set value 100
Start off
When the gate is standstill and it begins moving, the initial inertia
must be faced, therefore, if your gate is quite heavy, it could not
move.
In case the SPUNTO (pickup) function is activated, for the first 2
seconds of motion of each door, the control unit will ignore Pot value
and it will give motor the maximum power command in order to
overcome the gate inertia.
Function activated
Function deactivated
Starting ramp
In order not to stress too much the motor, when the motion starts the
power is gradually increased, until reached the set value or 100% if
the take-off is enabled.
Higher is the set value, longer the length of time of the ramp, that is
the time necessary to reach the value of nominal power.
Slow down in opening
Function deactivated
This menu allows regulating the percentage of the ride/drive that is
carried out at reduced speed during the last opening stretch
Slow down in closing
Function deactivated
This menu allows regulating the percentage of the ride/drive that is
carried out at reduced speed during the last closing stretch
t.PrE
t.PrE
- 47 -
AntE SCor
no no
1.0" 1.0"
time,
no no
60 60
Si Si
4 4
25 15
25 15
MEMO