Harbor Breeze PLM52CB5D Manual De Instrucciones página 8

FAN MOUNTING
4.
Depending on the length of downrod (A) you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you have
pulled them all the way through the top of the
downrod (A). Start at the TOP of the ball on the
downrod (A) and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters.
(Fig. 4)
NOTE: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
If you decided to cut back the lead wires in Step 3,
5.
strip 1/2 of an inch of insulation from end of white
wire. Twist stripped ends of each strand of wire
within the insulation with pliers. (Fig. 5) Repeat
Step 4 for black, blue (if applicable) and green
wires.
6. Install ball end of downrod (A) into mounting
bracket (C) opening. Align slot in ball with tab in
mounting bracket (C). (Fig. 6)
DANGER: Failure to align slot in ball with tab
may result in serious injury or death.
4
D
5
6
Ball
B B
8
Ball
A
C
Tab
Hanging
Ball Slot
A