Jøtul F 105 R Instrucciones Para Instalación página 15

Fig. 8
A
A
5. Lift the stove from the pallet.
6. Set up the stove and adjust using a cap wrench to a
horizontal position with the 4 height adjustment screws.
Mark on the wall if there has to be a rear outlet for flue pipe
and external air supply. NB: Take into account the height
of the floor plate.
Approval label
Fig. 9
7. Take the approval label (A) out of the burn chamber and
fasten it with the screw (B), as displayed. Tighten the screw
with a cap wrench. NB: Do not cut off the wire used for
fastening the label.
4.3 Preparations for Jøtul F 105 with
base
Fig. 10
A
A
8. Take out the gloves, baffle, bag of screws, external air
9. 1. Unscrew the screw placed in the middle of the rear side
10. Check that the control lever (A) moves easily.
11. Lift the stove from the pallet and set it up (see fig. 1).
A
A
3
connector and adapter lying in the burn chamber.
of the side plate.
2. Remove the side plate (C).
3. Remove the transport screw (D) that fastens the stove
to the wooden pallet.
ENGLISH
B
1
2
C
D
15