Servicing - Jøtul F 105 R Instrucciones Para Instalación

6.3 Sweeping flue pipes to the
chimney
Flue pipes must be swept through the flue pipe sweeping
hatch or through the door opening. The baffle and exhaust
deflector must be removed first.
6.4 Inspection of the fireplace
Jøtul recommends that you carefully inspect your fireplace
yourself after it has been swept/cleaned. Check all visible
surfaces for cracks. Also check that all joints are sealed
and that the gaskets are in the correct position. Any gaskets
showing signs of wear or deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer) and press the gasket
well into place. The joint will dry quickly.
6.5 Exterior maintenance
Painted products may change colour after several years'
usage. The surface should be cleaned and brushed free of
any loose particles before new paint is applied.
Enamelled products must only be cleaned with a clean, dry
cloth. Do not use water and soap. Any stains can be removed
with a cleaning fluid (oven cleaner etc.).

7.0 Servicing

Warning! Any unauthorised changes to the product are
illegal! Only original spare parts may be used!
7.1 Service/replacing parts in the burn
chamber
NB: Use tools with great care! The vermiculite plates may be
damaged if treated roughly.
Fig. 29
E
C
D
1. Baffle: Lift the front edge of the baffle (A) up and down and
twist it out of the burn chamber.
2. Exhaust deflector: Lift the front edge of the exhaust
deflector (B) up and down and twist it out of the burn
chamber.
3. Lift up the ash grate (D) in the middle slot in front and then
lift the ash pan out of the burn chamber
4. Remove the three screws holding the burn plate. Lift up
one of the sides of the burn plate and twist it out of the
burn chamber.
7.2 Replacing glass and gaskets in
the door
Fig. 30
1. Lift the front edge of the baffle (A) up and down and twist it
out of the burn chamber.
ENGLISH
B
A
E
A
23