Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Britax Child Safety, Inc.
Lap Belt Installation
1. Remove the tether
from the tether storage
compartment and retainer
tabs and place it up and
over the child seat back.
2. Place upright forward-
facing on the vehicle seat.
Ensure that the base of
the child seat is flat on the
vehicle seat and no more
than 3 in. (7.6 cm) of the
base hangs over the edge
of the vehicle seat (see
page 26).
3. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT
dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
4. Slide the vehicle belt into
the forward-facing belt
slots.
5. Ensure the vehicle belt is
not twisted and buckle
the seat belt.
6. Push down into the middle
of the child seating area
with moderate force
(approximately
45 lbs/20.4 kg),
compressing the vehicle
seat while tightening the
vehicle belt.
NOTE: Ensure that the
vehicle belt is locked as
directed by your vehicle
owner's manual.
18
3"
3a
3b
Publicidad
Capítulos
Tabla de contenido
