Husqvarna K6500 II Ring Manual De Instrucciones página 25

• Unscrew the knob. First turn the knob a few turns until
you feel a resistance. The guide roller then follows the
knob out and stops when it feels a resistance.
The guide roller is pressed into the knob. In order to
loosen the guide roller, you need to continue turning
the knob until it loosens completely.
• The guide roller can now be pulled out of the chassis.
• Screw the knob until it bottoms, and then loosen the
knob 2 turns.
• Insert the new guide roller in the chassis.
• Lubricate the guide rollers. See instructions under the
heading "Lubricating the guide rollers".
• Fit the blade.
• Assemble in the reverse order as set out for
dismantling. See instructions in the section
"Assembling and adjustments".
MAINTENANCE
Support rollers
• Replace the support rollers when the roller surface is
flat, when the groove on the roller surface has worn
away.
1) New
2) Worn
NOTICE! The support rollers do not drive the blade.
When worn rollers are replaced with new ones, you
must adjust the rollers against the blade.
Incorrect adjustment can result in damage to the blade.
See the instructions under the Assembly and Settings
heading.
If the blade rotates slowly or stops, stop cutting
immediately and trouble shoot.
Replacing the support rollers
Remove the support roller cover.
• Use a 19 mm fixed spanner and a 13 mm combination
spanner to replace the rollers.
–
English 25