Troubleshooting; Mechanics - Husqvarna K6500 II Ring Manual De Instrucciones

Mechanics

Problem Probable cause
Guide roller knobs not tightened fully.
The blade
The blade not fitted on guide rollers
does not
correctly.
rotate.
Support rollers tensioned too much.
Support rollers tensioned too much.
Worn drive wheel.
The V-shaped inner diameter of the
The blade
blade is worn.
rotates too
slowly.
The springs on the guide rollers are
weakened.
Defective guide roller bearings.
Defective support roller bearings.
Support roller setting too loose.
Worn guide rollers.
The blade
The blade not fitted on guide rollers
jumps out of
correctly.
its position.
Damaged blade.
Support rollers tensioned too much.
The blade
warps.
Blade overheating.
Segments
Bent, twisted or badly maintained blade.
break.
The blade cuts Wrong blade for the material in
too slowly. question.
The guide rollers does not move in and
out freely. A seized guide roller can not
press the blade hard enough against
the drive wheel.
Worn drive wheel. Abrasive material
and too little water when cutting
increases the wear on the wheel.
The blade
slips. Worn guide roller flange. When more
than half of the width of the flange is
worn the blade slips.
The blade's groove and inner edge are
worn. Caused by inferior flushing of
abrasive material and/or a worn drive
wheel causing the blade to slip.

TROUBLESHOOTING

Potential Solution
Tighten the guide roller knobs completely.
Refit the blade and make sure the blade moves, see section
"Assembling and adjustments".
Readjust support rollers.
Tighten the guide roller knobs completely.
Check for wear on the drive wheel, see section "Cutting
blades". Change if needed, see section "Assembling and
adjustments".
Check for wear of the blade, see section "Cutting blades".
Change if needed, see section "Assembling and
adjustments".
Replace complete guide roller assy or contact an
authorized service workshop.
Replace complete guide/support roller assy or contact an
authorized service workshop.
Readjust support rollers.
Check for wear on the guide rollers, see section
"Maintenance". Change if needed.
Refit the blade and make sure the blade moves, see section
"Assembling and adjustments".
Check for wear of the blade, see section "Cutting blades".
Change if needed, see section "Assembling and
adjustments".
Readjust support rollers.
Check the water flow, see section "Technical data"
Check for wear of the blade, see section "Cutting blades".
Change if needed, see section "Assembling and
adjustments".
Check blade recommendations, see section "Cutting
blades". Change blade if needed, see section "Assembling
and adjustments".
Check that the guide roller sleeves are free to move in and
out. If not, remove, clean, regrease and refit. See section
"Maintenance". Change if needed.
Check for wear on the drive wheel, see section "Cutting
blades". Change if needed, see section "Assembling and
adjustments".
Check for wear on the guide rollers, see section
"Maintenance". Change if needed.
Check blade, drive wheel and guide rollers, see section
"Cutting blades". Change if needed, see section
"Assembling and adjustments".
Check the water flow, see section "Technical data"
English – 27