Husqvarna 545 Mark II Manual Del Usuario página 25

™
AutoTune
Your product has the AutoTune
the carburetor automatically, which gives the best
possible adjustment. AutoTune
to weather conditions, altitude, gasoline and the type of
two-stroke oil.
CAUTION: If AutoTune
correctly, speak to your servicing dealer.
The product adjusts correctly after some
fuelings.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. 545 Mark II, 545G Mark II: Remove the center screw
(A), sleeve (B) and spring (C).
WARNING: You must be careful when
you replace the return spring or the
starter rope. The recoil spring is in
tension when it is wound up in the starter
housing. If you are not careful, it can
eject and cause injuries. Use protective
glasses and protective gloves.
544 - 005 - 10.05.2019
™
function that adjusts
™
lets the engine adapt
™
does not work
6. Remove the used starter rope from the handle and
the pulley.
7. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
8. Pull the starter rope through the hole in the starter
housing and the starter rope handle.
9. Make a tight knot at the end of the starter rope.
10. 545 Mark II, 545G Mark II: Assemble the spring (C),
sleeve (B) and center screw (A).
A
B
C
To tighten the recoil spring
1. Put the starter rope into the notch in the pulley.
2. Turn the starter pulley approximately 2 turns
clockwise.
3. Put your thumb on the pulley.
4. Pull the starter rope handle and pull out the starter
rope fully.
5. Move your thumb and release the starter rope.
6. Make sure that you can turn the pulley ½ turn after
the starter rope is fully extended.
To assemble the starter housing on the
product
1. Pull out the starter rope and put the starter in
position against the crankcase.
2. Slowly release the starter rope until the pulley
engages with the pawls.
25