SEVERIN PG 8539 Instrucciones De Uso página 14

heating element and the power cord
must not be immersed in liquid or even
allowed to come into contact with it.
∙ Do not allow the power cord to touch
any hot parts of the appliance.
∙ Always remove the plug from the wall
socket
- before filling the grill pan with
water,
- after use,
- in case of any malfunction, and
- during cleaning.
∙ The use of an extension-lead reel
causes a loss of power, possibly
combined with a subsequent heat build-
up in the cable. It is therefore necessary
to unwind the cable completely if a
cable reel is used. Make sure that the
reel is approved for outdoor use by the
manufacturer.
∙ Caution: Do not move the grill when it
is in use. Before carrying, transporting
or storing the grill, ensure that is has
sufficiently cooled down. Pour out any
remaining water after use.
∙ Ensure that the grill is not stored
outdoors, or in any other location where
it might be subjected to extremes of
temperature or high humidity.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This barbecue grill is intended
for domestic use only and not for
commercial applications.
∙ In order to avoid hazards, and to
comply with safety requirements,
repairs to this electrical appliance or its
power cord must be carried out by our
14
customer service. If repairs are needed,
please contact our customer service
department by phone or email (see
appendix).
∙ This product complies with all binding
CE labelling directives.
Heating element
The junction box contains a safety switch.
Place the heating element into the grill pan.
The safety switch is activated automatically
when the heating element has been
properly fitted. If not fitted correctly, the
appliance can not be switched on.
Before using for the first time
∙ Remove any packaging materials from
the appliance.
∙ Clean the grill rack and grill pan with
warm soapy water; wipe thoroughly dry
afterwards.
∙ Grill assembly:
∙ Place the heating element into the grill
pan.
∙ Fit the grill rack on top.
∙ If required, additional accessories may
be fitted according to the diagram.
∙ Fill the grill pan with water up to the
'Max' marking.
∙ Insert the plug into a suitable earthed
power-outlet.
∙ Let the grill heat up for approximately
10 minutes without any food on the
rack. This will lessen the smell typically
encountered when first switching on
a new grill (a slight smell and a little
smoke may be emitted).