Tabla de contenido
Publicidad
Ajuste el montaje de la manija (cont.)
Para ajustar la alineación de la manija:
NOTA: El adaptador de ranuras permite el ajuste fino de alineación de la manija.
Retire el adaptador de la espiga de la válvula.
Cambie la posición del adaptador de ranuras.
Vuelva a instalar el adaptador de la espiga de válvula y el montaje de la manija.
Verifique la alineación. Repita este procedimiento hasta obtener una alineación
satisfactoria de la manija.
3.
Install the Trim
Screws
Vis
Tornillos
Firmly press the valve stem adapter onto the valve stem.
Secure the valve stem adapter to the valve with the correct length screw, as
selected in the "Install the Valve Stem Adapter" section of this guide.
Align the holes on the front plate assembly and the valve.
NOTE: Be sure to select the correct length screw for your application.
Secure the front plate assembly to the valve with two screws. Do not overtighten.
Visually inspect the front plate assembly to ensure that the foam seal is completely
covering the wall opening. If not, stop the installation and repair the wall opening.
Place the escutcheon against the wall. The drain holes in the escutcheon should be
positioned downward.
Turn the handle assembly to the vertical 12 o'clock position.
Thread the handle assembly onto the hub of the front plate assembly to secure the
escutcheon in place.
NOTE: If the handle does not engage the valve or the escutcheon does not tighten to
the wall, replace the valve stem adapter with an adapter of appropriate length.
Kohler Co.
Valve Stem Adapter
Adaptateur de tige de valve
Adaptador de la espiga de la válvula
Screw/Vis/Tornillo
Front Plate Assembly
Ensemble de plaque
Montaje de la placa frontal
Escutcheon
Applique
Chapetón
7
Handle Assembly
Ensemble de poignée
Montaje de la manija
1117236-2-B
Publicidad
Tabla de contenido
