Assembly - Greencut GTC1200C Manual De Instrucciones

46

ASSEMBLY

ATTENTION: Do not connect the machine to the power supply until assembly is complete. Failure
to comply could result in serious injury.
MOUNTING THE LOWER HANDLE
1. Insert the lower handle into the holes located on either side of the motor
assembly.
2. Tighten the screws that hold the lower handle to the motor housing.
MOUNTING THE MIDDLE AND UPPER HANDLE
1. Slide the cable holder through the intermediate handle.
2. Place the top handle over the middle handle and align the holes. Screw in the two bolts and tighten the
fixing knobs by hand.
3. Hold the cable in the lower handle and centre the handle with the cable clip.
1