Product Use - Greencut GTC1200C Manual De Instrucciones

PRODUCT USE

ATTENTION: To avoid injury from accidental starts, always turn off the machine and disconnect it
from the power supply before moving it or making adjustments.
START UP
ATTENTION: Be sure to use an extension cable suitable for outdoor use (H05VV-F 2X0.75mm2)
attached to the power supply through a leakage protection system (RCD).
1. Connect the machine to the extension cable and then to the power supply.
STARTING AND STOPPING
1. Press and hold the safety lock button on the control box.
2. Pull the ON/OFF switch lever upwards towards the handle and hold
it in this position to start the engine.
3. Release the safety lock button.
4. To stop the machine, release the ON/OFF switch lever.
TIPS FOR WORKING
• The burs will pull the rudder forward during the operation, push the upper handle to lower the burs slowly.
• By pulling the rudder back, the burs will dig deeper and more aggressively.
• To break up the ground or perform deep ploughing, let the burs pull the rudder forward to the end of your arm's reach,
then pull the rudder firmly towards you. By repeating the forward movement of the rudder and then pulling the rudder
back, the work will be more effective.
• If the cutters sink deep enough to get stuck, move the handle gently from side to side to move the machine forward
again.
• To prepare the sowing field, we recommend using one of the following tillage patterns:
1. Tilling pattern A - Make two passes over the area to be ploughed, the second at a right angle to the first.
2. Tilling pattern B - Make two passes over the area to be ploughed, the second one overlapping the first one.
• Always allow the cutters to rotate at maximum speed; do not work in such a way as to overload the machine.
• When working on slopes, always stand diagonally to the slope in a robust and safe position. Do not work on
extremely steep slopes.
A B
47
EN
ON/OFF lever
Lock
button