Maneuvering - Husqvarna PG 820 RC Manual De Instrucciones

Maneuvering

General
The machine can be maneuvered both manually and with
a remote control.
Moving with support wheel
CAUTION! The support wheel should
!
only be used for moving short distances
within the work area and from a transport
vehicle to the workplace.
For more information, please see the 'Support wheel'
section.
• Lower the support wheel to raise the grinding unit
from the work area. Move the machine manually or
with the remote control.
Manual operation
When maneuvering manually, the wheel motors should
be disengaged from the wheels and the remote control
can be docked on the handle.
• Fix the remote control on the handle.
• Pull out and turn the spring-loaded locking pin on
each wheel to disengage the wheel motors.
OPERATING
Recommended working position of the machine.
Remote maneuvering
The machine is maneuvered wirelessly with radio
communication between the machine and the remote
control. For more information, please see the 'Remote
control' section.
!
Recommended working position for the machine when
maneuvering with remote control.
Remote control maneuvering with CAN
cable connected
The machine can also be maneuvered via the remote
control with the CAN cable connected between the
remote control and the machine. Can be used when the
remote control battery is flat.
CAUTION! Make sure the locking pins on
the wheel to the wheel motors are
depressed (locked position).
–
English 25