Operation - Husqvarna Rider 316T Manual De Usuario

4. Release the clip on the front cover with the tool
attached to the ignition key, and lift off the cover.
5. Pull the spring handle out from the spring holder to
loosen the drive belt tension.
6. Put the spring handle hook on the edge of the
equipment frame.
7. Remove the drive belt and put it in the belt holder.
8. Lift the cutting height stay and put it in the holder for
the cutting height stay.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
12
9. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
10. Push the equipment frame down. Lift the equipment
frame lock to vertical position.
11. Pull the cutting deck out.

Operation

To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 9 ).
WARNING: The lock mechanism can
cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position. Hold
the front edge of the cutting deck with
two hands when you continue to the next
step.
517 - 001 - 17.01.2018
Fuel safety