Husqvarna Rider 316T Manual De Usuario página 13

CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
To adjust the seat
WARNING: Do not adjust the seat during
operation of the product.
The seat can be tilted forward.
• To adjust the seat forward and rearward, push the
lever below the front edge of the seat up. Move the
seat to the required position.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model Rider 316T is found
behind the left rear wheel. Model Rider 316T AWD,
Rider 316Ts AWD, Rider 316TXs AWD has one drive
system lever for the front and one for the rear axle. The
517 - 001 - 17.01.2018
drive system lever for the rear axle is found behind the
left rear wheel.
The drive system lever for the front axle for Rider 316T
AWD, Rider 316Ts AWD, Rider 316TXs AWD is found
behind the left front wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
13