Husqvarna Rider 316T Manual De Usuario página 17

Maintenance
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Change the engine oil
Change the oil filter
Clean the air filter
Change the air filter
Change the fuel filter
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
Examine and adjust the steering wires
Examine the muffler and heat deflector
Examine the cutting deck for damages
Change the spark plug
Adjust the parking brake.
Do a check of and adjust the throttle wire
Clean the cooling fins on the engine and the transmission
Clean the engine and the transmission
Do a check of/adjust front and rear wheel speed, Rider 316T AWD,
Rider 316Ts AWD, Rider 316TXs AWD model only
Do a check of the belts
Do a check of the battery
Do a check of the fuel hose. Replace it if necessary
Change the oil in the transmission
Change filter in the transmission, Rider 316T AWD, Rider 316Ts
AWD, Rider 316TXs AWD model only
Change the spin-on filter of the servo, Rider 316T AWD, Rid-
er 316Ts AWD, Rider 316TXs AWD model only
517 - 001 - 17.01.2018
Daily maintenance
before operation
X
X
*
Maintenance interval
in hours
25 50 100 200
X
X
X X
X
X X
X X
X
X
X
X X
X X
O O
O
O
O
O
O
O
O
O O
O O
O
O
O O
O O
O O
17