Husqvarna Rider 316T Manual De Usuario página 4

Electrical system overview
1. Battery
2. Main fuse
3. Seat safety switch
4. Headlights
5. Microswitch, parking brake
6. Safety switch for the lift lever
7. Ignition lock
8. Hour meter
Seat safety switch
The seat safety switch starts the safety circuit when the
operator lifts from the seat. The engine and the drive to
the blades stop if the blades are engaged or the parking
brake is not applied. See also
8 .
Hour meter
The hour meter shows how many hours the engine has
run. The time with ignition on but engine off is not
registered. The last digit shows tenths of an hour (6
minutes).
Power outlet
The voltage of the power outlet is 12 V. The power outlet
To replace the main fuse on page 20 .
is fused, see
4
8
7
6
Safety circuit on page
1
2
Forward and reverse pedals
The speed is steplessly adjusted with two pedals. Pedal
(1) is used to move forward, and pedal (2) to reverse.
The product brakes when the pedals are released.
Cutting deck
The cutting decks for this product are Combi cutting
decks with BioClip. BioClip cuts the grass into fertilizer.
The Combi cutting decks can also be used without
BioClip. Without BioClip the grass is ejected to the rear.
Symbols on the product
WARNING: Careless or incorrect use can
result in serious injury or death to the
operator or others.
3
4
5
1
2
517 - 001 - 17.01.2018