Operation Of Your Opener; Specifications - LiftMaster 5580 Instrucciones

OPERATION OF YOUR OPENER

Your opener can be activated by any of the following devices:
• The Lighted Door Control Button. Hold the button down until door
starts to move.
• The Outside Keylock or Keyless Entry System (if you have
installed either of these accessories).
• The Remote Control Transmitter. Hold the push button down until
the door starts to move.
Opening the Door Manually:
Door should be fully closed if possible. Weak or broken springs
could allow an open door to fall rapidly. Property damage or
serious personal injury could result.
The door can be opened manually by pulling the release handle down
and back (toward the opener). To reconnect the door, pull the release
handle straight down.
Do not use the manual release handle to pull the door opener
or closed.
When the Opener is Activated by Remote Control or Lighted
Door Control Button:
1. If open, the door will close. If closed, the door will open.
2. If closing, the door will stop.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open or closed position,
it reverse direction.
5. If an obstruction is encountered while closing, the door will reverse.
6. If an obstruction is encountered while opening, the door will
reverse briefly.
7. The optional Protector System™ is automatically detected and an
invisible beam which, when broken by an obstruction, causes a
closing door to open and prevents an open door from closing. It
can be overridden only by the outside key lock, keyless entry
system or door control button. It is STRONGLY RECOMMENDED
for homeowners with young children.
Allow a 15 minute cooling period after 5 continuous operations
of the opener.
The opener light will turn on: 1. when opener is initially plugged in;
2. when the power is interrupted; 3. when the opener is activated.
The light turns off automatically after 2-1/2 minutes. Bulb size is
40 Watts maximum.
GARAGE DOOR OPENER WARRANTY
Chamberlain GmbH warrants to the first retail purchaser of this product (3780 or
5580) that the product shall be free from any defect in materials and/or
workmanship for a period of 24 full months (2 years) from the date of purchase.
Upon receipt of the product, the first retail purchaser is under obligation to check
the product for any visible defects.
Conditions: The warranty is strictly limited to the reparation or replacement of
the parts of this product which are found to be defective and does not cover the
costs or risks of transportation of the defective parts or product.
This warranty does not cover non-defect damage caused by unreasonable use
(including use not in complete accordance with Chamberlain's instructions for
installation, operation and care; failure to provide necessary maintenance and
adjustment; or any adaptations of or alterations to the products), labor charges
for dismantling or reinstalling of a repaired or replaced unit or replacement
batteries.
A product under warranty which is determined to be defective in materials
and/or workmanship will be repaired or replaced (at Chamberlain's option) at no
cost to the owner for the repair and/or replacement parts and/or product.
Defective parts will be repaired or replaced with new or factory rebuilt parts at
Chamberlain's option.
If, during the warranty period, the product appears as though it may be
defective, contact your original place of purchase.
This warranty does not affect the purchaser's statutory rights under applicable
national legislation in force nor the purchaser's rights against the retailer arising
from their sales/purchase contract. In the absence of applicable national or EU
legislation, this warranty will be the purchaser's sole and exclusive remedy, and
neither Chamberlain nor its affiliates or distributors shall be liable for any
incidental or consequential damages for any express or implied warranty
relating to this product.
No representative or person is authorized to assume for Chamberlain any other
liability in connection with the sale of this product.
114A2788G-en

SPECIFICATIONS

Max. Pull Force...............800N
Rated Power ...................400 W
Type................................Permanent split capacitor
Speed .............................1500 rpm
Volts................................230-240 Volts AC-50Hz Only
Noise level ......................60dB
Gears ..............................16:1 worm gear reduction
Drive ...............................Chain with two-piece trolley on
Length of Travel..............Adjustable to 2,3m (7-1/2 feet)
Travel Rate .....................96-135mm (3,8"-5,3") per second
Lamp...............................On when door starts, off 2-1/2 minutes
Door Linkage ..................Adjustable door arm. Pull cord trolley
Personal .........................Push button stop in UP and DOWN
Electronic ........................Automatic force adjustments.
Electrical .........................Motor overload protector and low voltage
Limit Device ....................Circuit actuated by limit nut.
Limit Adjustment .............Screwdriver adjustment on side panel.
Start Circuit .....................Low voltage push button circuit.
Length (Overall) ..............3,1m (122-1/2")
Headroom Required .......30mm
Hanging Weight ..............14,5 kg (32 lb)
Memory Registers ..........8
Keypad Code Memory ....1
SPECIAL NOTE: Chamberlain strongly recommends that the
protector system be installed on all garage door openers.
The undersigned, hereby declare that the equipment specified, and all
accessories, conforms to the Directives and Standards stated.
Model:
2004/108/EC
2006/95/EC
1999/5/EC
EN55014-1 (2000), EN55014-2 (1997), EN61000-3-2 (2000), EN61000-3-3
(1995), EN 301 489-3 (V1.3.1), EN 300 220-3 (V1.1.1), EN60335-1 (1994), and
EN60335-2-95 (2004)
A power door operator, in combination with a Garage Door must be installed and
maintained according to all the Manufacturer's instructions, to meet the
provisions of EN12453, EN13241-1 and Machinery Directive, 89/392/EEC.
B. P. Kelkhoff
Manager, Regulatory Affairs
THE CHAMBERLAIN GROUP, INC.
845 Larch Ave.
Elmhurst, IL 60126
USA
February, 2008
© 2008, Chamberlain GmbH
All rights reserved
Motor
Drive Mechanism
steel rail.
after stop.
release.
Safety
direction. Automatic force reversal in UP
and DOWN direction.
push button wiring.
Dimensions
Receiver
D e c l a r a t i o n o f C o n f o r m i t y
D e c l a r a t i o n o f I n c o r p o r a t i o n
5580, 3780