RIDGID R4222 Manual Del Operador página 38

Sierra ingleteadora
Ocultar thumbs Ver también para R4222:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ADJUSTMENTS
ADJUSTING THE MITER LOCK
See Figures 56 - 57.
 Unplug the saw.
 Locate the miter lock nut, miter lock screw and miter lock
shoe on the rear underside of the saw.
To adjust the clamping force of the miter lock:
 Lift the miter lock lever and press the miter detent bypass
to unlock the miter table.
 Rotate the miter table to an "unindexed" miter position
other than 0˚, 15˚, 22.5˚, 31.6˚, 45˚, 60˚, and 67.5˚.
 Push the miter lock lever down and attempt to move the
miter table. If the table moves easily when in the "locked"
position, adjust the miter lock screw.
 Using a 4 mm hex key, adjust the miter lock screw. Make
adjustments of one-quarter turn or less.
NOTE: Turning the miter lock screw clockwise will
increase the clamping force. Turning the miter lock screw
counterclockwise decreases the clamping force.
 After making the adjustment, test the clamping force.
NOTE: It should take considerable force to move the table
in the locked position.
To adjust miter table movement:
 Lift the miter lock lever, press the miter detent bypass,
and move the miter table left to right. If the miter table
does not move freely, adjust the miter lock nut.
 Using the 4 mm hex key, hold the miter lock screw
stationary and use a 13 mm combination wrench to adjust
the nut holding the miter lock shoe.
NOTE: Turning the miter lock nut clockwise will move
the shoe closer to the miter saw base and make it
harder to move the miter table. Turning the miter lock nut
counterclockwise will move the shoe farther away from
the base and make it easier to move the table.
 Adjust the miter lock nut until the shoe and miter saw
base are close but not in contact with each other.
 After making the adjustment, test the movement of the
miter table. The miter table should move freely left or right.
 Rotate the miter table to an "unindexed" miter position
other than 0˚, 15˚, 22.5˚, 31.6˚, 45˚, 60˚, and 67.5˚ and push
the miter lock lever down. Test the clamping force.
MITER LOCK
SHOE
38 - English
MITER DETENT
BYPASS BUTTON
UNLOCK
LOCK
MITER
LOCK LEVER
Fig. 56
MITER LOCK
NUT
MITER LOCK
SCREW
Fig. 57

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R4222t

Tabla de contenido