Cutting Height Adjustment; Mulching Operation - Snapper 7800849-03 Manual Del Operador

Cutting Height Adjustment

WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Pull the height adjusting latch (A, Figure 6) out-
ward and move to the desired cutting height.
Figure 6: Adjusting cutting height
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 7 (Figure 7). The
lowest cutting position is Notch 1.
1.25 in
3,18 cm
Figure 7: Cutting height settings (approximate)

Mulching Operation

For best mulching results, cut up to a maximum of 1/3
! of grass blade length and recycle ONLY when grass is
dry.
1. Set all wheels in the highest cutting position (Notch
7). Refer to the Section entitled "Cutting Height
Adjustment".
2. Move the engine speed control to the fast (Rabbit)
position.
3. Move the ground speed control to the slowest
speed setting.
4. Proceed mowing slowly. If the grass is very dense,
lower each rear wheel latch one notch lower than
the front wheel latches to improve mulching perfor-
mance.
NOTE: The mulching cover should remain on the
machine at all times, unless alternate discharge opera-
tions are desired, such as side discharging or bagging.
Removing the Mulching Cover
(Optional Accessory on Some Models)
!
A
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the nuts (A, Figure 8) securing the
mulching cover (B) to the mower deck.
NOTE: On some models, knob nuts and internal/exter-
nal tooth lock washers are used in place of nuts.
2. Remove the cover.
4.00 in
10,16 cm
Figure 8: Removing the mulching cover
Operation
WARNING
A
B
en
!
13