Installing The Discharge Deflector; Installing The Grass Bag - Snapper 7800849-03 Manual Del Operador

Operation
Installing the Discharge
Deflector
WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. Refer to the Section
entitled "Removing the Mulching Cover".
2. Install the deflector (A, Figure 9) to the deck in
place of the mulching cover, making sure that:
• The front hole (B) on the outside front of the
deflector fits over the stud where the front of the
mulching cover was originally secured;
• The slot (C) on top of the deflector slips under the
restraining nut on top of the deck (under the right
front corner of the engine);
• The slot (D) on the inside rear of the deflector
slips onto the stud behind the rear of the discharge
opening, where the rear of the mulching cover was
originally secured.
3. Install the nuts onto the studs and tighten securely.
NOTE: On some models, knob nuts and internal/exter-
nal tooth lock washers are used in place of nuts.
C
D
Figure 9: Installing the discharge deflector
WARNING
!
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace worn or damaged components
immediately.
14

Installing the Grass Bag

Adapter
(Optional Accessory on Some Models)
!
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. Refer to the Section
entitled "Removing the Mulching Cover".
2. Install the adapter (A, Figure 10) to the deck in
place of the mulching cover, making sure that:
• The front hole (B) on the outside front of the adapt-
er fits over the stud where the front of the mulching
cover was originally secured;
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right
front corner of the engine);
• The slot (D) on the rear of the adapter slips onto
the stud behind the rear of the discharge opening,
where the rear of the mulching cover was originally
secured.
3. Install the nuts onto the studs and tighten securely.
NOTE: On some models, knob nuts and internal/exter-
nal tooth lock washers are used in place of nuts.
B
A
Figure 10: Installing the grass bag adapter
!
WARNING
E
C
D
www.snapper.com
!
B
A