Snapper 7800968-01 Manual Del Operador página 27

Engine Drive Belt Replacement (Stretch
Type Belts - Continued)
IMPORTANT: Drain the fuel tank before tipping the
mower. DO NOT tip the machine with the carburetor or
spark plug down. Oil from the crankcase will saturate
the air filter and cause the engine to be hard to start or
not start at all. If contamination does occur, the air filter
will have to be replaced.
3. Remove the driven disc. Refer to the Section
entitled "Driven Disc Replacement" for driven disc
removal procedure.
4. Drain the fuel tank before tipping the mower. Do
not tilt the mower with the spark plug or carbure-
tor down. Tilt the mower up on its rear wheels
and remove the blade and blade hub. Assistance
from another person may be necessary to hold the
mower in the tilted position.
5. Hold the slotted end of the drive disc bolt (B,
Figure 35) with a screwdriver and remove the nut
(G) and internal tooth lock washer (F).
6. Remove the belt cover, located under the deck.
7. Lift the drive disc (A) up and remove the worn belt.
8. Loop one end of the new belt over the engine pul-
ley and insert the other end through the slot in the
deck.
9. Loop the belt around the pulley on the bottom of
the drive disc.
10.Reinstall the drive disc and retaining hardware.
IMPORTANT: 1) The square shoulder of the drive disc
bolt must fit into the square hole of the bushing. 2) The
square end of bushing must fit into the bracket slot.
11.Reinstall the belt cover and tighten the bolts
securely.
12.Reinstall the blade hub and cutter blade.
Recommended torque for the blade cap screw is
40 lb-ft (54 N.m).
B
C
E
G
Figure 35: Removing the drive disc
Transmission Poly-V Belt Replacement
1. Remove the driven disc. Refer to the Section enti-
tled "Replacing Driven Disc Rubber Ring".
2. Note the routing of the old belt around the three
pulleys before removing it.
3. Place the new Poly-V Belt (A, Figure 36) over the
end of the hex shaft (B) and onto the drive pulley
(C).
4. Work the belt onto the top of the idler pulley (D).
5. Twist the belt sideways and pull it upward between
the differential bracket (E) and driven pulley (F)
and then down into the pulley groove. Make sure
the Poly-V Belt is above the belt guide (G).
C
B
D
G
Figure 36: Poly-v belt routing
Maintenance
A
D
F
E
A
F
27
en