Eurosystems Z 8 Manual De Instrucciones página 15

6 During the machine transport and all the maintenance, cleaning, equipment change operations, the engine must be switched off.
7 Before leaving the machine, please switch the engine off.
8 Do not switch the machine on in closed rooms/areas where you can have carbon monoxide exhalations.
9 WARNING !! The petrol/gasoline is highly inflammable: Don't fill the tank neither in closed areas, nor when engine is on, don't smoke and be careful
to the petrol/gasoline loss from the tank. In case of leak, don't try to switch the engine on but move the machine away from the area in order to avoid
ignition source until the gasoline vapours fade away. Re-place the tank caps and the gasoline box.
10 Keep attention to the exhaust pipe. The parts near the pipe can reach 80°C.
Replace the defective and/or worn out silencers Burn hazards !!!.
11 Do not work on excessively steep slopes and take every precaution when changing direction or pulling the machine towards you.
12 Before putting the machine into operations, check it visually and make sure all the accident prevention measures are working. It is absolutely
forbidden to exclude and/or to tamper with them. Replace worn or damaged elements.
13 In case the machine is incorrectly used, and/or the repairs are performed by non-authorized technical staff, and/or fitted by equispare parts other
then original ones: any use other than that described above is prohibited and will involve the cancellation of the warranty and the refuse all
responsability from the manufacturer.
! ! ! ! !
SAFETY DEVICE (Fig. 9)
drive when the relevant levers are released (1) and (2).
! ! ! ! !
NOTES FOR WORKING WITH THE MOTOR-HOE (Fig. 9)
motor hoe firmly, push the spur into the ground. Pull the clutch lever (2) on the handlebar to begin hoeing. APPLICATIONS: soil working, hoeing,
breaking up, weeding, digging in composts or fertilisers, etc.
! ! ! ! !
DESCRIPTION OF THE COMPONENTS OF THE MACHINE (Fig. 19) :
lever REV 4) handle for engine recoil starter 5) spur device for tilling adjustment 6) tines 7) tines protection 8) tree saver disks
! ! ! ! !
HOW TO ASSEMBLE YOUR MOTOR-HOE
case. For assembly to be completed, the step/by/step procedure is as follows.
! ! ! ! !
FITTING THE DREWBAR (Fig. 2)
block the whole with a R-pin (4) . Then fit the shaft (5) to the other side of the shaft fixing it at the needed height using the screw and the nut (6).
! ! ! ! !
ASSEMBLY OF THE HANDLEBAR SUPPORT ( Fig. 3)
(3) and the nuts (4).
! ! ! ! !
HANDLEBAR ASSEMBLY ( Fig. 4)
the handlebar upper hole (A). Perform the same way with the slot (B) inserting the screw (10) into the handle (11) add the spacers (12) and complete
All the motor-hoes feature accident-prevention devices. Such devices cause automatic disconnection of the
Unless otherwise agreed, the motor-hoe is delivered disassembled and placed in a packing
Fit the support shaft (1) into the seat on the machibe (2) using the central seat hole , insert the pin (3) and
Fix the handlebar (1) to the support (2) using a passing-screw (7) , the washers (8) and the nut (9) into
With the motor running, rest the blades on the ground and, holding the
1) throttle drive lever 2) drive lever for tilling speed 3) drive
Assemble the support (1) on the tiller frame using 4 screws (2) the washers
7