Eurosystems Z 8 Manual De Instrucciones página 17

! ! ! ! !
SETTING THE CONTROLS (Fig. 9)
can be performed by adjusting the wire register (6-11). Furthermore, the lever that controls hoeing start (2) must only start the cutter after completing
half its travel.
! ! ! ! !
DRAWBAR ADJUSTMENT (Fig. 10)
loosen the screw (2) and make the drawbar to slide into the internal seat of the rudder , according to operator's own needs and to get the machine to
operate on an horizontal level. When the adjustments have been performed , tighten the screw (2).
! ! ! ! !
HANDLEBAR ADJUSTMENT
loosen the handles (11) and (13) and move the handlebar all the slot (B) long until you reach the most suitable position , then tighten the handles up
again. To perform a new side adjustment (Fig. 6) it is necessary to pull the lever up (1) and , in the same time, to make the handlebar to turn .To tighten it
is necessary to release the lever. In case the lever working should show to be inefficient , please unscrew or screw the nut (Fig. 15 - part. 2) which is
placed under the handlebar support.
! ! ! ! !
INSTRUCTIONS
Following the assembly & adjustment operations the motorcultivator is ready to start working.
ATTENTION ! Before switching the engine on, carefully check if the motorcultivator is in perfect good repair.
- Engine instructions: Carefully read the istructions booklet anclosed to the relevant engine.
- Check if the air filter is clean.
- Fill the tank in as per the fuel described in the engine specifications and using a filter filling funnel.
- Do not change the calibration of the speeds control rotation device of the engine in order not to over-speed it.
- HOW TO SWITCH THE ENGINE ON - DIESEL ENGINE : open the fuel handle ( only for the engines equipped with such device) and operate the
motorstop lever on ON position and the throttle one half its way. Concerning the switch on in cold engine, please read the engine instructions booklet.
Catch the starter handle and give a powerful pull to it. GASOLINE ENGINE : open the fuel handle ( only for the engines equipped with such device)
and position the throttle lever on START position. Concerning the switch on when the engine is cold , please read the engine instructions booklet.
Catch the starter handle and give a powerful pull to it. HONDA ENGINE GX160 : open the fuel handle ( only for the engines equipped with such device)
and operate the engine starter. Adjust the ON position the red switch which is placed on the throttle and put the lever for this last one half its way. Catch
the starter handle and give a powerful pull to it.
- Forward movement: grip the handlebars and pull the forward lever as far as it will go. (Fig. 9, part 2 )
- Reverse movement: release the forward lever (Fig. 9, part 2) and pull the other lever on the handlebar towards you (1). This motor hoe has
been designed to produce minimum vibrations and noise. Nevertheless, it is a good idea to interrupt long jobs with short pauses.
- WORK END : HOW TO SWITCH THE ENGINE OFF - DIESEL ENGINE : drive the motorstop lever to OFF position. GASOLINE ENGINE : drive the
throttle lever to STOP position. GX160 HONDA ENGINE : drive the switch put to the throttle to OFF position.
! ! ! ! !
SPEED ADJUSTMENT (Fig. 13)
adjustment it is normally enough to action the gearbox lever (Fig. 7 part. 1) . It is also possible to further adjust the forward speed operating on the belts
Important! The cutter must only start turning after the relevant controls have been set. This setting
To obtain a good digging and a correct tiller driving it is possible to adjust the drawbar height (1) ,
The handlebar can be both height and side adjusted. To perform the height adjustment (Fig. 4) you need to
According to the work requirements it is possible to adjust the tines rotation speed . To get such
9