Vega VEGAVIB S 61 Manual De Instrucciones página 22

8 Supplement
Ʋ Breaking capacity
Ʋ Contact material
Ʋ Note
Transistor output
Ʋ Switching voltage
Ʋ Switching current
Ʋ Blocking current
Modes (switchable)
Switching delay
Ambient conditions
Ambient temperature
Storage and transport temperature
Process conditions
Process pressure
Process temperature
Density
Electromechanical data
Options of the cable entry
Ʋ Cable entry
Ʋ Cable gland
Ʋ Blind plug
Spring-loaded terminals
Adjustment elements
Mode switch
Ʋ Min.
Ʋ Max.
Voltage supply
Relay output
Ʋ Operating voltage
Ʋ Power consumption
Transistor output
Ʋ Operating voltage
22
750 VA AC, 40 W DC (at U < 40 V DC)
If inductive loads or stronger currents are switched
through, the gold plating on the relay contact surface will
be permanently damaged. The contact is then no longer
suitable for switching low-level signal circuits.
AgNi or AgSnO2 each with 3 µm gold plating
Floating transistor output
max. 55 V DC
max. 400 mA
< 100 µA
min./max.
on: approx. 0.5 s
off: approx. 1 s
-40 ... +80 °C
-40 ... +80 °C
-1 ... 16 bar/-100 ... 1600 kPa
-50 ... +150 °C
> 0.1 g/cm³
M20 x 1.5
M20 x 1.5
M20 x 1.5
for wire cross-section up to 1.5 mm² (AWG 16)
Min. detection or dry run protection
Max. detection or overflow protection
20 ... 253 V AC, 50/60 Hz, 20 ... 72 V DC (at
U >60 V DC, the ambient temperature can be max.
50 °C/122 °F)
1 ... 8 VA (AC), approximately 1.3 W (DC)
10 ... 55 V DC
VEGAVIB S 61 •