Using The Cassette Deck (Recording) - JVC RC-BZ5LB/RD Manual De Instrucciones

Playback
1. Press the § STOP/EJECT button to open
the cassette holder.
2. Insert a cassette tape with the exposed
side facing upward as shown below.
+
Forward direction
3. Close the holder gently until it clicks.
4. Press the TAPE PLAY button.
• The tape is played and then stops when it reaches the end.
To pause, press the 8 PAUSE button on the Unit.
Using the Cassette Deck
8
§
1
Things To Know Before You Start
Recording —————————————
It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the con-
sent of the owner of copyright in the sound or video re-
cording, broadcast or cable program and in any literary,
dramatic, musical, or artistic work embodied therein.
The correct recording level is automatically set by the ALC
(Automatic Level Control) function, and is not affected by the
VOLUME control on the Unit or by the use of sound effects.
Two small tabs on the back of the cassette tape, one for side A
and one for side B, can be removed to prevent accidental erasure
or recording.
To record on a cassette with the tabs removed, you must cover
the holes with adhesive tape as shown.
Notes:
• Use normal tapes (not metal or CrO
• At the start and end of cassette tapes, there is leader tape which
cannot be recorded onto.
• If a recorded tape you make has excessive noise or static, the
Unit may have been too close to a TV during the recording.
Either turn off the TV or increase the distance between the TV
and the Unit.
¶
REC
3
¡
tapes) for recording.
2
To cancel pause, press the 8 PAUSE button again. Play contin-
ues from the point where it was paused.
To stop playing, press the § STOP/EJECT button.
To remove the tape, stop the tape, and press the § STOP/
EJECT button again.
To Fast-Forward and Rewind a
Tape
Press the 1 (fast-forward) button on the Unit to
fast-forward the tape.
Press the ¡ (rewind) button on the Unit to re-
wind the tape.
• The Cassette Deck automatically stops when the tape reaches
its end.
(Recording)
REC indicator
(Display when using the Cassette Deck)
Recording from the Radio
1. Press the § STOP/EJECT button to open
the cassette holder.
2. Insert a blank or erasable cassette tape
with the exposed side facing upward as
shown below and wind past the leader tape.
+
Forward direction
3. Close the holder gently until it clicks.
4. Tune in to a radio station.
5. Press the ¶ REC button on the Unit.
The PLAY button is pressed at the same time, the "REC" indi-
cator lights up, and the Unit begins recording.
• The tape is recorded and then stops when it reaches the
end.
To pause the recording, press the 8 PAUSE button on the Unit.
To cancel pause, press the 8 PAUSE button again. Recording
continues from the point where it was paused.
To stop recording, press the § STOP/EJECT button.
To remove the tape, stop the tape, and press the § STOP/
EJECT button again to open the cassette holder.
7