Cleaning The Filters - Oster BVSTEM6701B Manual De Instrucciones

CLEANING YOUR AUTOMATIC ESPRESSO,
CAPPUCCINO, AND LATTE MAKER
CLEANING THE MILK RESERVOIR AND FROTHING TUBE
Although you can store the milk reservoir with leftover milk in the refrigerator, it is important
to clean the reservoir and frothing tube regularly to avoid clogging and residue build-up. In
order to clean the milk reservoir, please follow the instructions listed below:
1. Remove the milk reservoir from the unit by lifting up on the milk reservoir release
button and simultaneously sliding milk reservoir out, grabbing milk reservoir by lid.
2. Remove the lid of the reservoir.
3. Dispose of any milk left, then rinse and wash the milk reservoir and its lid thoroughly
with warm soapy water. Make sure to rinse and dry them well. Do not use abrasive
cleaners and scouring pads, as they will scratch the finish.
NOTE: The milk reservoir is also dishwasher safe (top rack). Do not place the lid of the
milk reservoir in the dishwasher.
4. Fill milk reservoir with water, not above the MAX fill line. Place milk reservoir back
onto unit, lifting up on reservoir release button and simultaneously sliding milk
reservoir in, holding reservoir by the lid.
5. Place a large empty cup under the froth dispensing tube.
6. Press the clean "
dispensing tube. Let the cleaning cycle run for a few seconds until you no longer see
any milk coming out of the tube. Once finished, press the clean "
again to stop the process.
7. Dispose of any water left in the milk reservoir and place it back in the unit. You should
feel the milk reservoir lock in place.

CLEANING THE FILTERS

1. To remove the black plastic piece from under the filters, rotate it counterclockwise
towards the unlock icon "
2. Wash the black plastic piece and filter with warm soapy water. Make sure to rinse
and dry them well.
3. Place the black plastic piece back onto the filter by inserting it in its place and then
rotating it clockwise (away from the unlock icon "
CLEANING THE BREW HEAD, THE PORTA-FILTER AND FILTERS
1. Press the on/off "I/O" switch located on the right side of the unit to the off position
"O" and unplug the power cord from the electrical outlet.
2. Some of the metal parts may still be hot. Do not touch them with your hands until
they have cooled.
3. Remove the porta-filter and discard the coffee grounds, used pod or used
Nespresso capsule. Wash both the porta-filter and filter thoroughly with warm soapy
water. Make sure to rinse and dry them well.
NOTE: Do not wash the porta-filters and filters in the dishwasher.
4. Wipe the lower part of the brew head in the unit with a damp cloth or paper towel to
remove any coffee grounds that might have been left.
5. Place the porta-filter (without any filter) back in the brew head in the unit and lock it
in place.
6. Place a large empty cup under the porta-filter.
7. Plug the power cord into the electrical outlet. Press the on/off "I/O" switch to the
on position "I".
8. Press the Espresso " " button once and let the unit brew with water until it
stops automatically.
" button. The unit will start releasing steam through the froth
".
E n g li s h - 13
" button once
") until you hear it click.