Machine Installation; Uncrating Machine; Installing Batteries - Nobles SpeedGleam Manual Del Operador

Pulidora con control de polvo de 36v
Ocultar thumbs Ver también para SpeedGleam:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MACHINE INSTALLATION

UNCRATING MACHINE

Carefully check carton for signs of damage. Report
damages at once to carrier.
Check Machine Contents to ensure package is
complete. Contact distributor for missing items.
Machine Contents:
2 - Battery Cables #223364
6 - Black Battery Boots #68872
1 - Battery Tray #604298
1 - Dust Bag, Cloth (Installed) #900210.
1 - Dust Bag, Paper #611781
1 - 20 inch Hair Blend Burnishing Pad (installed)
#611788 - Carton of 5.
3 - 12V 225AH Batteries #1070591 (included with
machine #9003534 and 9003538 only).
To uncrate your machine, remove shipping straps and
carefully lift or use a ramp to remove machine from
pallet. Do not roll machine off pallet, damage may
result.
ATTENTION: To prevent machine damage, install
batteries after removing machine from pallet.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
ATTENTION: You must remove wire- tie before
operating machine.
Nobles SpeedGleam/Plus (04- 14)

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Recommended Battery Specifications:
Three 12 volt, deep cycle, 225 amp hour batteries.
Part Number #1070591. Maximum battery dimensions
are 178 mm (7 in)W x 394 mm (15.5 in)L x 362 mm
(14.25 in) H.
1. Park the machine on a level surface.
2. Turn the main power switch to the OFF position
and remove key, if equipped.
3. Unlatch and hinge open both the dust bag hood
and the battery hood to access the battery
compartment.
Remove the two loose battery cables and cable
boots from the battery tray (Figure 1).
4. Carefully install the batteries into the battery tray
with the battery posts arranged as shown. Then
place the battery carrying handles on top of the
batteries to allow clearance for battery hood
(Figure 2).
OPERATION
FIG. 1
FIG. 2
7

Publicidad

Tabla de contenido
loading

Tabla de contenido