Machine Installation; Uncrating Machine; Attaching Squeegee Assembly; Installing Batteries - Nobles Speed Scrub 2701 Manual De Operación Y De Piezas

MACHINE INSTALLATION

UNCRATING MACHINE

Carefully check carton for signs of damage. Report
damages at once to carrier. Check carton contents to
ensure all accessories are included. Squeegee is
packaged with machine. Batteries, battery charger and
pad driver(s) are packaged separately. (Batteries not
included with Pac #609238 or 609239)
ATTENTION: Battery installation must be
accomplished after removing machine from
shipping crate.
To uncrate your machine, remove shipping straps and
raise brush head. To raise brush head, step down
firmly on the bottom brush lift foot pedal until pedal
locks into the raised position. Carefully lift or make a
ramp using crate boards to remove machine from
pallet.
ATTENTION: Do not roll machine off pallet,
damage may occur.

ATTACHING SQUEEGEE ASSEMBLY

1. Pull back on squeegee lift lever to raise squeegee
mount bracket.
2. Loosen two thumb knobs on squeegee and slide
squeegee into slots at rear of squeegee mount
bracket. Be certain that squeegee roller wheels
are toward the rear (Figure 1).
3. Tighten thumb knobs securely.
Speed Scrubt 2701/3301 (06–01)
FIG. 1

INSTALLING BATTERIES

WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective gloves when handling batteries or
battery cables. Avoid contact with battery acid.
Recommended Battery Specifications:
Four 6 volt, deep cycle, 305 amp hour batteries. Part
Number #130870. Maximum battery dimensions are
178mm (7 in) W x 308mm (12.13 in) L x 356mm
(14 in) H.
1. Turn all switches to the OFF position and pull out
the Main Power circuit breaker button as shown
(Figure 2).
ATTENTION: To prevent motors from accidental
starting, be certain to pull out the "MAIN" circuit
breaker button before installing batteries.
2. Carefully hinge open recovery tank to access
battery compartment. Make sure recovery tank is
empty before opening. Remove loose battery
cables from compartment (Figure 3).
OPERATION
FIG. 2
FIG. 3
5