WA8600M_DC68-03774C-04_EN.indd 25
1. Connect the ends of the water supply
hoses to the hot and cold faucets.
2. Tighten the fittings by hand until they
are snug, and then tighten them an
additional two-thirds of a turn with
pliers.
CAUTION
When you fasten the fittings, do not fasten
them too tightly or apply tape or sealant to
the faucets or water supply intakes. This can
damage the fittings.
NOTE
After you have connected the water supply
hoses to the faucets, ensure that they are
connected correctly by pulling the water
supply hoses downwards.
3. Place the unconnected ends of the hoses
into a bucket and open the faucets
connected to the two water supply hoses
for 10 or 15 seconds to remove any
foreign substances from the hoses. Close
the faucets before continuing.
English 25
2019-02-14
5:36:26