B
STEP 5 Powering your washer
WA8600M_DC68-03774C-04_EN.indd 29
3. If the washer is level, the pulsator
(A) will be positioned at the center of
the tub as shown in the figure on the
previous page. If it isn't, level your
washer by turning the front leveling
feet clockwise or counterclockwise as
necessary.
NOTE
Turn the front leveling feet clockwise (B) to
lower the washer, and counterclockwise (C)
to raise the washer.
C
Plug the power cord into a 3-prong, well
grounded, 120 volt 60 Hz, approved
electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you installed your washer
correctly by running the RINSE+SPIN after
the installation is complete. See Step 6 on
the next page.
English 29
2019-02-14
5:36:29