Samsung WA52M8650A Serie Manual Del Usuario página 30

Installation
STEP 6 Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Press POWER to turn on your washer.
3. Select RINSE+SPIN by pressing the Cycle Selector.
4. Press START/PAUSE to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the "STEP 2 Connecting the water supply hoses" section on page 24 for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP
4 Leveling your washer" section on page 28 for instructions.
STEP 7 Calibration Mode
Your Samsung washer detects laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after installation is
complete.
To run Calibration Mode, follow these steps:
1. Remove laundry or any contents from the washer, and then turn it on.
2. Press Temp. and Delay End simultaneously for at least 3 seconds when the power is
turned on.
3. Press START/PAUSE to activate Calibration Mode.
4. The pulsator rotates clockwise and counterclockwise for approximately 1 minute.
5. When Calibration Mode is finished, "0" appears in the display, and the washer
automatically turns off. The washer is now ready for use.
30 English
WA8600M_DC68-03774C-04_EN.indd 30 2019-02-14 5:36:29