Standard Accessories - HIKOKI RH 600T Instrucciones De Manejo

the switch in OFF position. If the switch is
left in ON position when power resumes,
the restart of the fan may cause fi re.
CAUTION
1. Parts of the nozzle supplied are sharp,
so use gloves when removing them
from the case and when attaching or
detaching them.
2. The hot wind release nozzle, the tip of
the nozzle and the material that was
heated are extremely hot during and
immediately after using the tool, so use
gloves and avoid touching them directly.
3. Do not use inside boxes, drawers or
other enclosed spaces.
Aiming it constantly at a single location
may result in the outbreak of smoke or
fi re.
SPECIFICATIONS
Type
Voltage
Power supply
Rated electrical
current
Power Input
Wind volume
Capacity
Wind temperature
Motor type
Weight

STANDARD ACCESSORIES

1 Nozzle (round) ............................................................. 1
2 Nozzle (fl at) ..................................................................1
3 Nozzle (curved surface) ...............................................1
4 Nozzle (glass protector) ...............................................1
5 Scraper (with grip) ........................................................1
6 Case .............................................................................1
Standard accessories are subject to change by area.
Standard accessories are subject to change without notice.
4. Make sure the nozzle is at least 5cm
5. Do not switch the tool on and off
6. Do not point the heat-wind release
Can be used with both 50 Hz and 60 Hz single-phase current.
110 V
12.9 A
1375 W
0.25 m
250 – 500°C
2-stage switch
50°C
(When the cooling button is used.)
APPLICATIONS
○ Peeling off paint
○ Softening adhesive
○ Removing putty from window frames
○ Forming resin pipes
○ Welding plastic
○ Heat wrapping using heat-shrink fi lm.
○ Soldering
○ Drying work
○ Defrosting work
away from the item being heated when
using the tool. Also, do not cover or
otherwise block the nozzle.
Failure to observe this may result in
the Heat Gun overheating, leading to
malfunctions.
repeatedly. Also, do not use the tool with
the power cord folded or twisted.
Failure to observe this may result in
malfunctions.
nozzle downwards immediately after
use.
Failure to observe this may result in the
tool overheating, leading to malfunctions.
120 V to 127 V
12.2 A
1500 W
/min to 0.5 m /min (2-stage switch)
3 3
350 – 500°C
2-stage switch
50°C
(When the cooling button is used.)
Direct current motor
0.57 Kg
English
220 V to 240 V
8.8 A
2000 W
450 – 600°C
2-stage switch
50°C
(When the cooling button is used.)
7