In Case Of Sd Error - Sharp XE-A406 Manual De Instrucciones

In Case of SD Error

2
If an error occurs while data is transferred from your cash register to the inserted SD memory card and vice
versa, it will be indicated by a corresponding error message shown on the operator display. Press the
clear the error, then take the corresponding action.
SD error message table
Display
(Error message)
NO CARD No SD memory card is found. Insert an SD memory card into the SD card slot or reinsert it correctly.
CARD PROTECT The write-protect switch on the SD memory card is in the "PROTECTED" position. Set the switch on
the "NOT PROTECTED" position.
CARD FULL The SD memory card is full. Delete unwanted data from the card on a PC or replace the card with a
new one. When using a new SD memory card, be sure to format it in advance.
ACCESS ERROR The SD memory card has no desired data. Replace it with another SD memory card containing the
desired data.
FILE FAILED The data stored in the SD memory card is incorrect. Write correct data into the SD memory card on a
PC.
OVER LIMIT. The maximum allowable number of times of sales data writing is exceeded. Delete unwanted data
from the SD memory card on a PC or replace the card with a new one. When using a new SD memory
card, be sure to format it in advance.
POWER OFF A power failure has occurred while the SD memory card is accessed. Perform the interrupted
operation again from the beginning after power recovery.
SD CANCEL The data transfer operation has been canceled. Perform the same operation again from the beginning.
SD ERROR An error other than the above mentioned has occurred while the SD memory card is accessed.
Perform the interrupted operation again from the beginning.
70
Error status and action
l
key to