Installing The Shoulder Strap - Chapin Tree/Turf Pro 61950 Manual De Uso Y Cuidado

SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft
(A) aligning the pump handle hole and shaft hole. Push the straight
side of the cotter pin (B) through the aligned hole as shown in figure
1 thru 3. There are holes in the pump handle to allow for either
left(fig.4) or right (fig.5) hand mounting.
Figure 1
Cotter Pin
Figure 4
Left Hand
STOWAWAY PUMP HANDLE
Pull
up
INSTALLING THE
SHOULDER STRAP
The top of the shoulder straps
are attached to the tank.
Attach the lower end of the
straps by clipping the strap
hooks to the metal frame
between where the frame
exits the tank and curves
around.
Figure 2
Line up holes
Figure 5
Right Hand
Rotate
180º
Figure 3
Slide pin through holes
Set
into
slot
WAND CLIP
The wand can be
attached to the
pump handle
using the wand
clip.
3E
C
Pump Handle
Positioned For Use
(right hand shown)
A
B