Installing The Shoulder Strap - Chapin ProSeries SMKCPD0015L Manual De Instrucciones

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle holes and shaft holes. Slide the bolts (B)
through the aligned holes as shown in figure 3. Tighten nuts (D) to bolts.
There are holes in the pump handle to allow for either left (fig.2-4) or
right (fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt

INSTALLING THE SHOULDER STRAP

The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap hooks to the
metal frame between where the frame exits the tank and curves around.
WAND CLIP
The wand can be attached
to the metal frame using the
wand clips.
Retaining Nut
Wand
Pump
Handle
Figure 2
Line up holes
Figure 5
Right Hand
Wand Clip
O-ring
Pump
Shaft
3E
Shut-off
Valve
A. Pump Shaft
D. Nuts
C. Pump Handle
Figure 3
Slide bolts through holes
Completed Assembly
B. Bolts