Installing The Shoulder Strap - Chapin ProSeries 63800 Manual De Instrucciones

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump
shaft (A). To install the pump handle place the handle (C) over
the shaft (A) aligning the pump handle hole and shaft hole. Push
the straight side of the cotter pin (B) through the aligned hole as
shown in figure 1 thru 3.
Figure 1
R Clip

INSTALLING THE SHOULDER STRAP

The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap
hooks to the metal frame between where the frame exits
the tank and curves around.
WAND CLIP
The wand can be attached to
the pump handle using the
wand clip.
O-ring
Wand
Figure 2
Line up holes
Wand Clip
3E
Shut-off
Valve
Figure 3
Slide clip through holes