Warning; Introduction; Technical Details; Gravity Version - Sagola 4100xtreme Serie Manual De Instrucciones

1. Warning

Before starting the unit you must read, take into consideration and comply with all the indications
described in this Manual.
This manual must be kept in a safe place, accessible to all users of the unit.
The unit must be started and handled exclusively by personnel instructed in its use and must be
employed only for the purpose for which it was designed.
Likewise, accident prevention standards, regulations, work centre directives and current legisla-
tion and restrictions must be taken into consideration at all times.
SAGOLA S.A., the logotypes of SAGOLA and other SAGOLA products mentioned in this manual, are
registered trademarks or brand names of the company SAGOLA S.A.

2. Introduction

This unit belongs a the family of devices designed to spray products with compressed air with a
spray gun, providing a high level of product transfer (T > 65%) and excellent quality finish, as well
as low levels of contamination.
The equipment consists of the following:
_ Spray gun
_ Accessory wrench
_ Cleaning brush
_ Instruction manual
_ Case

3. Technical details

Net weight:
Gravity Version (without cup)..........................................................................................................515 g.
Pressure Version............................................................................................................................530 g.
Suction Version (with cup)..............................................................................................................880 g.
Ceramic Version/PD Version..........................................................................................................552 g.
Maximum operating temperature of 50ºC.
Recommended working pressure not in excess of 2 bar (measured at the air inlet and recorded
in this).
Air consumption according to Nozzle Table
Community directive complied with
Explosive atmosphere (Atex)
(*) Non electric gun in explosion hazard areas (ATEX) must have the earthing connections and/or static-free feed hoses.

3.1. Gravity Version

Gravity fed unit (hereinafter the Gun) with Tip and Air Nozzle of the type described on the
packaging. Product cup with a capacity of 0.65 litres, fitted with an anti-drip plug, product filter and
device for collecting drained product.
Maximum air inlet pressure to gun 8 bar.
3.2. Pressure Version/Ceramic/PD
Pressure fed unit (hereinafter the Gun) with Tip and Air Nozzle of the type described in the packaging.
Maximum air inlet pressure to gun 8 bar.

3.3. Suction Version

Suction fed unit (hereinafter the Gun) with Tip and Air Nozzle of the type described in the packaging.
Product cup with a capacity of 1 litre with filter product.
Maximum air inlet pressure to gun 8 bar.
94/9
II 2G X
(*)
ENGLISH