Bluetooth Setup; Registering A Bluetooth Device (Pairing); Selecting The Bluetooth Device; Bluetooth Device Registration Test - Kenwood KDC-BT752HD Manual De Instrucciones

Bluetooth Setup

Registering a Bluetooth Device
(Pairing)
Registering from this unit
Press to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [DEVICE
4
SEARCH], then press to enter.
Search for the Bluetooth device.
When search is completed, "FINISHED" is
displayed.
Turn the volume knob to select a
5
Bluetooth device name, press to confirm.
"CONFIRM DVC" is displayed
6
If "PAIRING OK" is displayed, proceed to
step 9.
If "PIN CODE" is displayed, proceed to steps
7.
If "*** NG" is displayed, press the volume
knob. Proceed to steps 6.
Input the PIN code
7
To select the number, turn the volume
■ ■
knob.
To move to the next digit, press ¢.
■ ■
To delete the last digit, press 4.
■ ■
Press the volume knob to transmit the
8
PIN code.
If "PAIRING OK" is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
the procedure mentioned in <Registering a
Special Bluetooth device>.
Hold to finish the procedure.
9
To cancel the Bluetooth mode, press
■ ■
If there are 5 or more Bluetooth devices
■ ■
registered, you cannot register a new
Bluetooth device.
Registering a Special Bluetooth device
Press to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
22
English
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [S-DVC
4
SELECT], then press to enter.
Turn the volume knob to select a device
5
name, press to confirm.
Go through the procedure step 4
6
of <Registering from this unit> and
complete the registration (pairing).
If the device name is not in the list, select
■ ■
"OTHER PHONE".

Selecting the Bluetooth Device

Press
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [PHONE
4
SELECT] or [AUDIO SELECT], then press
to enter.
Turn the volume knob to select a
5
Bluetooth device name.
Press the volume knob to set up the
6
Bluetooth device.
"✱ (device name)": The selected
■ ■
Bluetooth device is busy.
"- (device name)": The selected Bluetooth
■ ■
device is on standby.
"(blank) (device name)": The Bluetooth
■ ■
device is deselected.
If a cell-phone is already selected,
■ ■
deselect it, and then select a different
one.
Hold
7
To cancel the Bluetooth mode, press
■ ■
.

Bluetooth Device Registration Test

You can check whether your Bluetooth device
can be registered using this unit.
Press and hold
1
mode
"PAIRING" is displayed.
Search for the Bluetooth device.
When search is completed, "FINISHED" is
to enter Bluetooth mode.
to finish the procedure.
to enter easy pairing
.