Using Non Fading Output; Adjusting Non Fading Output Level; Using The High Pass Filter; Adjusting Source Levels - Pioneer PREMIER SUPER TUNER IIID DEH-P560MP Manual De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
08
Audio Adjustments
3
Press a or b to adjust the output level
of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer. +6  6 is displayed
as the level is increased or decreased.

Using non fading output

When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1
Press AUDIO to select non fading out-
put on/off setting.
Press AUDIO until NOFAD:ON appears in the
display.
# When the subwoofer controller setting is only
P/O :FUL, you can switch to the non fading out-
put on/off setting. (Refer to page 41.)
2
Press a to turn non fading output on.
NOFAD:ON appears in the display. Non fading
output is now on.
# To turn non fading output off, press b.

Adjusting non fading output level

When the non fading output is on, you can ad-
just the level of non fading output.
1
Press AUDIO to select non fading out-
put setting.
Press AUDIO until NOFAD: 0 appears in the
display.
2
Press a or b to adjust the output level
of the non fading.
Each press of a or b increases or decreases
the level of the non fading. +6  6 is displayed
as the level is increased or decreased.
38
En

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1
Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
2
Press a to turn high pass filter on.
HPF : 80 appears in the display. High pass fil-
ter is now on.
# If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of HPF : 80.
# To turn high pass filter off, press b.
3
Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
5080125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Note
If you switch the SFEQ setting, the HPF function
is automatically turned off. By turning the HPF
function on after selecting the SFEQ setting, you
can combine HPF function with SFEQ
function.

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.

Publicidad

Tabla de contenido
loading

Tabla de contenido